GARY single cut Slitter
| GARY 3354 Rotary Slitter |
| Capacity : 16 Gauge (.06") |
| Throat : 24" |
| Motor : 1/3 HP, 110 volts |
| Minimum Slitting Width : 1" |
| Maximum Slitting Width : 24" |
| Shipping Weight : 450 lbs. |
Sturdy 24 inch throat slitter with quick adjusting back gauge and scale. Made in USA.
Click to request a formal quote for this machine
- Die-set type gauge mounting that insures easy setting and consistent squareness.
- Gauge mounting rods are extended to provide convenient carrying handles.
- Gauge is easily removed for machine transport and re-installed with no resquaring.
- Slitter knives are proven GARY "quickset" design manufactured from tool steel
- Knives are outboard mounted for easy access knives are reversible , intervals between sharpening is double that of a single edge knives.
- "Adiprene" stripper rings are non-marking and serve to hold the material flat reducing twist.
- Dual bearings mounted at knife end to minimize deflection and increase knife life.
- Heavy duty roller chain drive with by 1/3 HP gearmotor.
- Standard 110 volt with grounded plug. 6 amps.
- Options: Stand, extra Knives, Stripper Rings
GARY sheet fed multiple cut Slitting machines
GARY 3350DX Slitter
Maximum number of simultaneous cuts:
- 30 gauge (.015") metal: 6 cuts
- 28 gauge (.018") metal: 4 cuts
- 26 gauge (.021") metal: 3 cuts
- 24 gauge (.024") metal: 3 cuts
- 22 gauge (.031") metal: 3 cuts
- 20 gauge (.036") metal: 2 cuts
- 18 gauge (.048") metal: 1 cut
- 16 gauge (.060") metal: 1 cut
Click to request a formal quote for this machine
- 3" diameter cold - roll turned, ground and polished shafts mounted in dual wall ball bearings lubricated for life.
- Gauge mounted on each side for left or right hand use.
- End frames are aluminum - magnesium alloy.
- Rugged lightweight GARY torsion tube assembly.
- Heavy gauge steel with "T" bar reinforcement.
- Slitter knives are proven GARY "quickset" design manufactured from tool steel.
- Knives are "reversible", intervals between sharpening is double that of a single edge knives.
- 2 sets of standard 3" X 5" X 3/4" wide high-carbon tooling is included.
- 40 FPM standard operating speed.
- Heavy duty roller chain drive powered by 1/3 HP gearmotor.
- Standard 110 volt with grounded plug.
- Maximum sheet width: 49"
- Cutting rate: 40 feet per minute
- Machine weight: 480 Lbs.
- Made in USA